EH40 workplace exposure limits explained

Workplace exposure limits (WELs) are Britain's occupational exposure limits: the maximum concentration of a hazardous substance in the air that workers breathe, averaged over a set time. HSE approves them and publishes the list in EH40/2005 Workplace exposure limits. The current version is the fourth edition, 2020, which brought in 13 new or revised limits from 17 January 2020. HSE offers it as a free PDF.

Long-term and short-term limits

EH40 explains that WELs are time-weighted averages (TWA) over two periods:

Where a substance has no short-term limit listed, EH40 says a figure of three times the long-term limit should be used. Limits are given in ppm (parts per million) for gases and vapours and in mg/m³ (milligrams per cubic metre). For dusts, inhalable and respirable dust are the fractions collected by HSE's standard sampling method, MDHS14/4.

What the notations mean

SkCan be absorbed through the skin, where there are concerns that skin absorption will lead to effects in the body. Air monitoring alone won't show the full exposure.
CarcCapable of causing cancer and/or heritable genetic damage.
SenCapable of causing occupational asthma.
BMGVA biological monitoring guidance value exists, listed in EH40 Table 2.

WELs and COSHH

EH40 states that a substance with a WEL is subject to COSHH. Control counts as adequate only if good practice is followed, the WEL is not exceeded, and exposure to asthmagens, carcinogens and mutagens is kept as low as is reasonably practicable. EH40 also warns that a substance missing from the list is not therefore safe. For those, exposure should be kept to a level nearly all workers could breathe every day without harm.

WELs for common workplace chemicals

SubstanceLong-term (8-hour)Short-term (15-minute)
Acetone500 ppm (1210 mg/m³)1500 ppm (3620 mg/m³)
Propan-2-ol (IPA)400 ppm (999 mg/m³)500 ppm (1250 mg/m³)
Methanol (Sk)200 ppm (266 mg/m³)250 ppm (333 mg/m³)
Hydrogen chloride1 ppm (2 mg/m³)5 ppm (8 mg/m³)
Hydrogen peroxide1 ppm (1.4 mg/m³)2 ppm (2.8 mg/m³)
Ammonia, anhydrous25 ppm (18 mg/m³)35 ppm (25 mg/m³)
Sodium hydroxideNone listed2 mg/m³
Sulphuric acid (mist)0.05 mg/m³None listed
Liquefied petroleum gas1000 ppm (1750 mg/m³)1250 ppm (2180 mg/m³)
Portland cement10 mg/m³ inhalable, 4 mg/m³ respirableNone listed

Mixtures such as petrol, diesel and white spirit have no single WEL. EH40 lists some of their components, such as benzene at 1 ppm, and describes a calculation for in-house limits for hydrocarbon solvents.

Where to find a product's limit

Section 8 of the safety data sheet lists exposure limits, but it may quote other countries' limits next to the UK ones. Check the figure against EH40 itself. Our COSHH sheets give the EH40 limit for each product and say where EH40 has none.

Source: HSE, EH40/2005 Workplace exposure limits, fourth edition 2020, paragraphs 3-7, 13-14, the notation key and Table 1.

Opening soon at £19 a month

Unlimited assessments, cancel any time. The tool isn't open yet, so there is nothing to pay today.